Power monitor setup

It seems impossible to set the power monitor.

No matter which options i use, it is impossible to save the Amperage reading.

Without this it is impossible to do the motor to compass calibration.

This problem is happening both for Clone Pixhawk as well as for the Pixflacon Power module.

The voltage i manage to to do OK but seems impossible to to save the Current value. I enter it and when going back it changes to NULL.

Please help

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • I think there is a value at full parametrs for changing the Amper

    BATT_AMP_PERVOLT

    You should change this value and write params

This reply was deleted.

Activity