I have experience with the KK2 and the CC3D but am new to the APM 2.5 which has many more features and capabilities. I have built a new H copter and installed the APM 2.5 board. I was wondering if there is any special power up sequence with the following hardware on my quad?
- APM2.5
- Rx
- GPS w Compass
- MAVLink OSD
- 3DR radio
- ESCs
Or can I just connect the battery and go?
Thanks
Replies
As long as you've done the setup and calibration (http://copter.ardupilot.com/wiki/initial-setup/) you can just connect the battery and go.
There's no specific power-up sequence - the parts are designed to be powered up at the same time.