Hello,
Just installed new quadro with 3.0.1 soft and have problem with accelerometer calibration - always finish with fail message.
Compass calibration working ok.
Accel - in CLI mode - showing parameters - 0.9x 0.9x 5.6x
What is the reason of such high value in thord position (Z?) ?
This APM 2.5 module previously was used in plane - and working perfect.
Marek
Replies
Hi All,
I have the same problem - FAIL every time.
The APM 2.5 module was moved from a previous quad where it performed without fault.
Moved it to my new quad, updated to the latest firmware and now I cannot get past the accelerometer calibration.
Any thoughts? very frustrating......
Daz