Hello everyone.

I am trying to configure PX4Flow with Pixhawk. I have followed the instruction and created /etc/extras.txt with the text "mavlink start -d /dev/ttyS2 -b 115200 -m custom" and connected the PX4board to TELEM2. it's still isn't working. I need help here. plz let me know what I am doing wrong. I am using windows7 and using both mission planner and QGroundControl software. 



Views: 625

Reply to This

Replies to This Discussion

Have you had any success with this? I am facing this exact challenge.

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service