Hi

After the "radio calibration" procedure is done I'm getting the message that channel 2,4,5 or 1.6.7…. "Failed to set channel x". Every calibration the error is in deferent channels. Only one time I didn’t get any error.

However, the channel PWM summary looks OK and all channels are working:

  1. What is the problem?
  2. Is it safe to fly after getting this message?

The setup:

Mission Planner 10

Pixhawk with last Arduplane firmware

Thanks for helping,

Itzik 

Views: 111

Reply to This

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service