Setup Problem using the APM Mission Planner

Hi,

 

I'm trying to configure my APM for quadcopter use using the APM Mission Planner.

 

I've been through the documentation and set up the COM ports as instructed and have the CLI slider switch toward the servo headers.

 

When I lauch the terminal in the APM Mission planner, I get the following response:

3690866828?profile=original

The APM mega board has all three leds lit ie red, amber and blue and the oilpan shield has a blue light lit. When I launch the APM Planner the TX and RX LEDs flash.

 

My PC is running windows 7 Ultimate and the FTDI drivers seemed to install correctly and without incident.

 

I'd be interested to hear anyone's thoughts on the possible cause of this so I can get it fixed.

 

Many thanks in advance,

Tim

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Hi Tim

    Were you able to solve , i have 100% the same issue....

    Regards

    Anton
  • Developer
    try 57600 and 38400, depending on what quad software you are using.
  • Developer
    please check your baud rate, id guess it is set wrong
This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…