About

Gender

Male


Location

Johannesburg


About Me:

Live in Sa


Please tell us a bit about your UAV interest

Trying to build unit. To assist in game counting / monitoring


Hometown:

Sasolburg


Activity Feed

Anton de Jager left a comment for Anton de Jager
"Hi Hein
Was hoping to get some assitance from a local source, i have some issue with my Ardu installation, i have posted on forum but very few takers, .....
 
GroeteA."
Oct 11, 2011
Anton de Jager replied to Adrian M.'s discussion HIL problems
"I have exactly same problem any assistance will be appreciated"
Oct 2, 2011
Anton de Jager replied to Anton de Jager's discussion Xplane test flight .. Help needed, (waypoints ignored)
"I have since had it working but today all works tomorrow it will not work???"
May 28, 2011
Anton de Jager replied to Anton de Jager's discussion Help needed with testing on Xplane
"I have since gotten to the same point and yes experiencing the exact same thing, it would work perfectly and then next time no sim data, i have found that going into explane and changeing ip to another range and then in ardupilot sim, works…"
May 23, 2011
Anton de Jager posted a discussion
Finally to this point i have through help from all mastered everything to this point...Thnx to all.. Finally my test flight in XPLANE, all works well plane takes of and flies, my modes (only 3 for now) manual stabilize and auto. My problem is the…
May 18, 2011
Anton de Jager replied to Anton de Jager's discussion Cannot access CLI
"Lowering baud, and loading firmware sorted this issue"
May 9, 2011
Anton de Jager replied to Anton de Jager's discussion Help needed with testing on Xplane
"Still battling checked, xplane settings as per manual, still no luck...."
May 8, 2011
Anton de Jager posted a discussion
HiI have been able to sort most issues with the help of some members thnx for that. I am now at the point to test my flightplan /setup with xplane. I have 2560 board and oil pan with GPS. I have done setup through cli, and have uploaded waypoints to…
May 7, 2011
Anton de Jager replied to T Shaw's discussion Setup Problem using the APM Mission Planner
"Hi Tim

Were you able to solve , i have 100% the same issue....

Regards

Anton"
May 5, 2011
Anton de Jager posted a discussion
I get opening com port and then random characters, According to the manual i should see thisThis will bring up the Terminal window, and if your APM slider switch is in the right postition (towards the RC connectors), you should see the APM CLI…
May 5, 2011
Anton de Jager posted a discussion
Anyone please asssit i am not able to access my board...  New board new installation....i have changed Baud to 115..... Also checked RTS, loaded latest drivers, buty get this.. Any ideas?? Opened com portf0f0??????
May 4, 2011