Discussions

SPC1000 and HMC5843 connection to ArduIMU+ V2

Posted by Nathaniel Caner on June 22, 2010 at 3:09pm

Simple question....there was a picture posted in a discussion here a awhile back showing the ArduIMU+ V2 connected to both the SPC1000 pressure sensor and the HMC5843 magnetometer. I've been searching for it for about an hour, can't seem to find it. Anyone able to point me to the right discussion?

Thanks

You need to be a member of diydrones to add comments!

Join diydrones

Replies are closed for this discussion.

Replies

Dr Mike Black June 22, 2010 at 3:39pm

I think its under TWI (I2C) interface if what i had read has sunk in....im sure that one of our fearless leaders can put you right on this.

Mike.

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

More…

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.