I am trying to change my "sr1" settings in the mission planner setup.
I make a change and upload them. The changes do not take.. If I read the pixhawk config, they are on different values than I set.
I found some old posts where people had this issue in APM planner, and the solution was to use mission planner. But I'm using mission planner! I had this working several months ago, so I'm not sure if it's due to a new version of mission planner or arducopeter.. but something changed..
Should this be working?
Thanks.
You need to be a member of diydrones to add comments!
Replies
Hi, i have exactly the same issue with my pixhawk controller, i connect to mission planner, successfully update the firmware, calibrate it. then unplug it, reconnect it to mission planner and none of my settings have been saved.
I am convinced the board is faulty, i bought a new controller and works perfectly, so i know its not my laptop or drivers etc.
I also checked the onboard battery in side the pixhawk and it was fullcharged, i also replaced the mirco sd incase it was faulty, but same problem.