I'm not able to calibrate my Radio using QGC, in my Pixhawk(roll and throttle not moving). I tried to install all the versions like ardurover, copter etc, but none of them is working. But when I installed PX4, it was working. Then I tried with APMPlanner, then there it is functioning properly. After calibrating in the APMPlanner, if I connect with QGC, throttle and roll will again stop working. I'm not able to understand what the problem is. Any help?

Views: 8

Reply to This

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service