hi everyone!

is there anyone who knows about Y harness. i have one output from co pilot computer for ailerons and i need to use this output for two servos. Y harness does this job pretty good. But i dont have it. can i use two servo extension cable by joining them in parallel like Y harness or is there any buffer circuit used in Y harness separation node. I think it causes current draw. is it problem for servos.

Views: 297

Reply to This

Replies to This Discussion

No buffer is required with a Y harness--just soldering together two servo cables is fine.
thanks Chris!
it will be very helpful.

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2020   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service