Crow flaperons on APM 2.5 successful!

Posted by k.rusydi85 on September 19, 2012 at 11:11pm

Hello people,

Posted here couple days ago regarding setting flaps more specifically crow flaps into APM2.5. Today after tinkering with the code finally a breakthrough.

I can set the innerboard surfaces flaps only  with the outer board raising up when i activate the switch and i can also make them full crow flaperons.

Currently its on the latter..don't know how effective or what bad flight tendencies can occur.

Another question is, how much up deflection should i set the outer board elevons ? Currently its exactly the same as the inner boards. Or should i reduce.

I'll try post some vids later

Hopeto hear some opinions :-)

Cheers,

Rusydi

You need to be a member of diydrones to add comments!

Join diydrones

Tags: apm, apm25, crow, flaperons, flaps
Email me when people reply –
Follow

Replies

  • Marc MERLIN July 26, 2014 at 4:45pm

    This was a long time ago, but I've never seen any config to get flaperons working with APM.

    Did you post yourrs somewhere, or can you point to a place that has something more recent?

    Thanks,

    Marc

  • Moderator
    Graham Dyer November 14, 2012 at 4:28am

    What changes did you make to the code? Can you post them here? I'm looking to try get flaperons working.

  • Shannon Morrisey September 19, 2012 at 11:20pm

    Very nice. Will use it as soon as available. Been looking orward to something like this ever since differential support was added.

This reply was deleted.