Slow Mission Planner Reponse!

Posted by Colin Johnston on September 14, 2012 at 8:44pm

Having issues with Mission Planner 1.2.11 mav 1.0 and arduplane2.62...I've run several previous versions of the Mission Planner and ArduPlane and never had any issues at all with speed..It seems to be very slow and not very responsive..I can run the IMU test from the MP terminal and it appears to run fine. Not sure if its something I'm doing or if there is something wrong..I can move the IMU around and it updates really slowly

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Colin Johnston September 15, 2012 at 2:56pm

    Anybody else got any more ideas..

    I've tried to reset/erase eeprom and reload code, disk defrag, changed usb cable and port,all of the comments above and still response very sluggish..

  • Colin Johnston September 15, 2012 at 12:28pm

    3692506445?profile=originalSeems like its dropping packets!?

  • steve September 15, 2012 at 4:57am

    I have this problem too but have always resolved it by restarting the APM. For some reason I've always felt it was because I moved the APM during the boot process where the gyros are calibrating. In my case they delay comes from the APM because you can see it's reactions when moving the plane by hand in stable mode. I have mine set for manual level but I still make sure not to disturb it when booting up and I rarely have the problem now. Usually only when I'm updating the software and the plane is sitting on a nearby unstable chair ;-)

  • Developer
    Michael Oborne September 14, 2012 at 10:04pm

    please try the following.

    1. install newer graphics card drivers.

    2. install newer directx.

    3. in the planner options turn on gdi+

This reply was deleted.