two motor with different speed.

Posted by Ben on June 29, 2015 at 2:34am

hi everyone.

i build a boat with two bushed motor and brushed ESC( V 2.4.9 firmware was used), when i begin to push the throttle, one motor work(1),other do not work(3). when the throttle on 1/3 position, two motor both work.

has anyone encountered this problem.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

- Ben June 29, 2015 at 8:30am
  
  i am sorry，it is pixhawk，i will test tomorrow
  thanks！
- Ben > Grant Morphett June 29, 2015 at 5:19am
  
  yes, i have 2 brushed ESCs
- Darius Jack > Ben July 12, 2015 at 4:25pm
  
  Could
  
  you kindly explain me the problem ?
  
  Emailed messages have no-reply status.
  
  Reply Deleted
  
  So how to reply anyway, is peer-to-peer communication not supported ?
  
  ==
  
  Reply Deleted
  
  This reply has been deleted. Return to the discussion.
  
  ===
  
  Ben replied to their discussion "two motor with different speed." in ArduBoat User Group on DIY Drones
  
  ------------
  
  @Darius Jack My ultimate goal is to build
  
  ==
Darius Jack June 29, 2015 at 3:17am

Can you replace motor connectors to know if the problem is with a control unit or a motor, connector?

Check voltage, current values.

of 2

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

ArduBoat User Group

Replies