The kit went together easy enough however it seems I have a bad ESC at least one and a bad PDB, I have been going back in forth with customer service, sent a video of the problem, well the first one to then a week later to say we will have to replace the part.
I guess I was hoping for a bit more and since this is one of the 3 multicopters that I have built in the past 3 weeks, and starting I figured this one would go together the smoothest and possibly the quickest... It may have if I have not been fighting gremlins...
At this point it seems quite slow, and at this rate I am questioning if this will get off the ground before I hit my 30 day limit...
Hoping this will get better as it looks like this may the the multicopter that we film on the bench and do our best to describe the copter that does not fly...
Replies
Tried my first maiden after I got my replacement parts and it immediately flipped to the right and crashed breaking two props any ideas why it would not fly? I will double check motor layout however I checked this already
Check out the common setup errors here.
I think I just had some bad luck, broke it down checked it all, tried again with new props, however it seems I have 3 SPF 11" props that I can't use...
Anyway, got a basic however was going to run autotune then my frsky jxt errored our.... Should have the replacement by tomorrow so hopefully I will have it sorted and working