Replies

  • Same here - Motors don't start spinning (anymore) with 3.1 and FRAME=10.

    After inital upgrade to 3.1, it worked fine, but now, after I've done some modifications (including the Y6-mod and replacing a motor), I can't get the motors start spinning when armed anymore...

    I've already re-loaded 3.1, done ESC calibration again (and again) - but with no success.

    But when giving the Y6 some throttle, the motors start spinning like they should.

    Any help would be appreciated!

    Philipp

    2013-12-28.param

  • Did you do esc calibration? http://copter.ardupilot.com/wiki/initial-setup/esc-motor/

This reply was deleted.