Is anyone using this frame? I got it but am in doubt about which motors to use.
http://www.goodluckbuy.com/butterfly-x250-330mm-shaft-mini-quadcopter-glassfiber-frame-74g.html
I got it with the intention to use my little tiny hobbyking motors that I had on jose's mini frame but I think this frame was intended for slightly bigger motors and those were really fragile and the mounting holes in the frame were bigger than the motor.
Also I don't want to use prop savers because those o rings always brake when least expected :)
So anyone found some good motors that would fit this? I plan to put APM2 on it and probably with 22003S or 4S battery.
Replies
I've narrowed it down to these choices.
http://www.goodluckbuy.com/flylite-2804-1750kv-outrunner-brushless-...
http://www.ebay.com/itm/4X-A1504-2900KV-Brushless-10g-Motor-MINI-25...
http://www.hobbyking.com/hobbyking/store/%5F%5F8494%5F%5FTurnigy%5F...
All about the same price but not sure about quality. Also seems they would all mount with little adaption.
I'm definitely planning to use 3S of various sizes up to 2200mAh if possible. And with 5 or 6" props if you see they fit. I just didn't want a lot of disturbance because of the props being to close together. I heard that can cause stabilization problems.
Should I look for a higher KV or lower? I should go higher KV with smaller props right? I just plan to carry the APM1, GPS and maybe xbee.
Maybe this with some 5" GWS5043 props. http://www.goodluckbuy.com/flylite-2804-1750kv-outrunner-brushless-... and 10amp turnigy ESC's.