Can not connect to Telemetry

Posted by Edgar Scott on September 22, 2013 at 9:50am

Picture shows MP found it on COM 6, Driver loaded.  

Does not show is lights green on PC module, on Air module one light green and one yellow.

Tried to load settings, Upload Firmware Local and nothing works :(

3691062145?profile=original

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Admin
    Thomas J Coyle III September 22, 2013 at 6:46pm

    @Edgar,
    In the movie "Now You See Me" one character says: "The closer you look, the less you see" :-)
    Regards,
    TCIII Admin

  • Admin
    Thomas J Coyle III September 22, 2013 at 10:08am

    @Edgar,

    Does the MP picture above indicate a USB connection or a telemetry radio connection as both the APM and the PC telemetry radio use FTDI ICs for the USB communications? If it is showing a telemetry radio connection, then the baud rate should be 57.6K and not 115.2K.

    Regards,

    TCIII Admin

This reply was deleted.