Replies

  • Jeraz D. Engineer October 24, 2014 at 10:10am

    You can generate gerber files using the board files available. Gerber files are sometimes tailored according to the board houses that would be producing them, so ideally it would be better to create them from the board files using EAGLE software. Again tons of material online showing you how to create gerber files from board files in eagle.

    • yuvraj > Jeraz D. Engineer October 24, 2014 at 7:43pm

      Thanks for your reply jeraz !

  • Admin
    Thomas J Coyle III October 24, 2014 at 8:46am

    @yuvraj,

    I believe that the APM2.6 board layout and schematic are only available in Eagle format which can be found here Link at the bottom of the page.

    Regards,

    TCIII AVD

    • yuvraj > Thomas J Coyle III October 24, 2014 at 8:58am

      Thanks Thomas for the reply

      Can you have the components list which is installed in the APM 2.6 PCB board that can be more help-full for me @ Thomas :)

      Yuvraj. 

    • Admin
      Thomas J Coyle III > yuvraj October 24, 2014 at 9:18am

      @yuvraj,

      No, I do not know where you can obtain the parts list other than to look at the part numbers on the schematic.

      Regards,

      TCIII AVD

    • yuvraj > Thomas J Coyle III October 24, 2014 at 9:29am

      Thanks You Thomas :) have a nice day :) 

      Regards 

      Yuvraj.

This reply was deleted.