Minimosd

Posted by Daniel Estes on September 20, 2014 at 10:38am

I purchased the Minimosd from 3D Robotics and everything is wired and works between my quad and FPV.  My problem is when I go to the Minimosd-Extra to configure the panel layout on my PC.  I keep getting the following message.  "Failed to Upload New Config Data".  After that message, I get the following.  "Eeprom Mapping Updated".  

I am using the 3DR FTDI cable.  There is power when connected and I see the Minimosd led blink when I select the COM port.  

Need some help.  

Thanks.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Daniel Estes September 20, 2014 at 6:21pm

    Got it working.

    I would recommend the most current Minimosd config software/firmware to be easier to locate on the web.  There are some variants out there, and in my case, they caused some problems.  

This reply was deleted.