TBS Disco Pro with APM 2.6

Posted by Edgar Scott on December 21, 2013 at 12:31pm

I have started a new build, this time a TBS Disco Pro.

Wanting to know if there is anything others have had and if there are any known issues I should be aware of.

Here is my APM location.

3691085329?profile=original

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Muhammad Abdul Hadi January 7, 2014 at 5:57pm
    Hi Edgar, no problemo buddy....good to know.....fly safe and fave fun :-) ....my GPS stand is coming, it has a cover for the GPS too, will post a pic when it gets here insha Allah
  • Muhammad Abdul Hadi January 7, 2014 at 5:20pm
    Hi Edgar,
    that's unfortunate, Alhamdulillah I blocked of all the holes and put a new finer black sponge inside the APM, measuring around 30x15cm, made sure to cut out an area near the LEDs, apparently the sponge inside was a pink number inside :-) and mounted on thick sponge and its flying well. Managed to complete autotune twice...the 1st time switched of autotune before disarming.....the 2nd time without putting it into althold....boy did it fly high (there was lots of space, a huge open field) but completed. Insha Allah I will post a couple of vids after the autotune to show loiter.
    On you toilet bowl effect....only thing I can think off is the usual balancing of props and minimizing vibration bro....sorry I am not that experienced on the APM
  • Euan Ramsay December 21, 2013 at 12:40pm

    Make sure you can still reach the usb socket once the arms and cables are in place.

    And...errrr...make sure the APM is facing the right direction...

    And make sure the servo in cables from the rx dont snag the core shield. And watch 1 & 2 outputs too - they can snag the risers.

This reply was deleted.