Hello,I have a strange stuff going on: i have a new APM 2.5 board. I want to configure it with ardurover firmware. I plug the usb cable, i open the latest mission planner and i load the ardurover firmware. So far, so good.After that mission planner starts going nuts, saying and displaying "Armed", and other stuff that do not correlate with the real status of the board. My APM board is new, not connected to anything.Is there an imcompatibility between the latest mission planner and ardurover ?
You need to be a member of diydrones to add comments!
i have done a full eeprom cleanup with "erase" and "reset" in CLI. I reloaded the latest firmware and now I have a situation that may be normal but not sure: is it normal that it goes in ARMED status automatically and immediately after I connect to the board
(i guess it is but would like confirmation).
It goes automatically in mode "Learning".
I still have an issue with the 2S battery voltage and current measurement and failsafe but that 's my other two posts.
Replies
hello,
i have done a full eeprom cleanup with "erase" and "reset" in CLI. I reloaded the latest firmware and now I have a situation that may be normal but not sure: is it normal that it goes in ARMED status automatically and immediately after I connect to the board
(i guess it is but would like confirmation).
It goes automatically in mode "Learning".
I still have an issue with the 2S battery voltage and current measurement and failsafe but that 's my other two posts.
Have you done your RC setup yet?