Replies

  • Mike Kelly February 14, 2016 at 7:54am
    I had someone try to print this and he could not get the top to print correctly. Anyone else try to print it successfully?
    • Mirko Denecke > Mike Kelly February 16, 2016 at 11:58am

      @Mike Hi Mike, which file do you use?

    • Mike Kelly > Mirko Denecke February 16, 2016 at 5:19pm

      Actually I had him try both. I got back what he tried to do today. It looks like the tall base and the lip on the top for the lid is too thin and breaks thru on the recess for the top.

      I can glue it and get it to work.I'll take a picture for you.

    • Mike Kelly > Mike Kelly February 17, 2016 at 11:32am

      He tried a number of times and this was the best attempt:

      3702808484?profile=original

      3702808273?profile=original

    • Mirko Denecke > Mike Kelly February 18, 2016 at 12:00pm

      That is the result here:

      3702857236?profile=original

      3702857352?profile=original

    • Developer
      Linus > Mike Kelly February 17, 2016 at 11:47pm

      Hi Mike,

      that looks like the results i have seen.

      I don't own a 3D printer yet but got a few cases printed out by a friend.

      Cheers

      Linus

    • Mike Kelly > Linus February 18, 2016 at 5:43am

      It just needs a little re-enforcement behind the indentation for the lid.

  • Vinicius Juvinski September 3, 2015 at 12:11pm

    Hi Mirko,

    are you thinking in some arrangement to cover the barometer? 

    Regards and congratz

    • Chris > Vinicius Juvinski October 8, 2015 at 4:23am

      I've been using the the foam and tape method, it seems to work but I'm a few weeks off putting mine in the air.

This reply was deleted.