Hi everybody:
I install a Fatshark system on my Iris+, I build this servo based pan tilt base, this is just for fun, I think that the installation is OK.. At begin I just want to fly with the cam I don't think to active the servos but now after those flights ( really nice at all ) I can stop here. I wonder if I can conect to Pixhawk to control the pan tilt from the remote. Somebody can help me!? I have other copters but I have to say this is really fun to fly. It transmit fine I need to know if I can connect it, if yes where? and then how to setup the remote? Other thing wich is the better cannel to transmit with the fat shark... I have some noise at the video! I am not a expert I am new to this. BTW sorry about my english... Thanks!!! More attached potos...
Replies
Of course the operation of setting up more than just an on/off command is probably much more simple than the processes to setup an rc signal that controls the pan and tilt on your servos.
Just go buy the dys 3axis gimble and set it up for pan tilt thru the stock iris receiver. I use the 3dr light view set up with the 200 mw vtx and the black pearl lcd screen. Works great when viewing thru the go cam. Also you may want to move the gray wire away from all other wires to improve your signal. Tape it to the side of the iris instead of zip tying it to your servo wires. It is some what shielded but not that much.
Thank Gregg for your answer, but the interesting here is experiment with this config I have it in my house and I want to install properly, so I can learn something new about the servo setting up... THE ENJOY OF THE EXPERIMENT I dont want to buy, I have another one that have all the device atached yet. I want to do this for fun and the feling of do it by my self. I don't know if do you follow me?