Gimbal still jerking after firmware, re-calibration, motor, the works

Posted by Heller Gregory on April 29, 2015 at 7:06pm

I've tried everything!!  It was jerking, so went to get the firmware and re-calibrate.  Took me hours to figure out the driver just wasn't compatible w/ Windows 8.  Everything is installed and supposedly calibrated, and it's STILL jerking and won't just point down smoothly like it did before this happened?  

Any other ideas?  I've scoured the web and did everything.  After 3 days of this, I'm still in the exact same spot.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

    • Heller Gregory > Al Caudullo April 29, 2015 at 9:28pm

      It's probably the controller.  It levels straight just fine, it's when I tilt it on the remote it starts jerking.  I'll look up how to do that, everything else is installed & it's flying really well.  

    • Dan McKenna > Heller Gregory April 29, 2015 at 9:56pm

      I here:

      The drone flies well which points to the gimbal...yes?

This reply was deleted.