Greetings,
I'm very new at flying with Iris, but after I land and move the control stick to the disarm position, I need to disconnect and reconnect the battery to fly again.
Is this common/expected?
Often I'll fly for 3-4 minutes, then need to check something, so I land, check things over, then want to take off again. Nothing happens until I disconnect/reconnect the battery.
Ideas?
Thanks,
John
Replies
Thanks for the additional data. I'll investigate further. I was hoping to get out today for some test flights in the back yard, but by the time I charged the battery, it had started to rain.
I'll try to capture more information about the conditions when I need to unplug/replug the battery.
Thanks!
John
Correct - I'm trying to re-arm IRIS, and I see no lights, no sound and no movement until I disconnected and reconnect the battery.
This does not happen all the time, but more than half of the time.
Here are the steps I'm following:
1) Fly
2) Land IRIS
3) Move left stick to lower left to disarm motors
4) Press safety button
--- do other things for minute or so (leaving transmitter on)
5) Press safety button - get solid red light
6)Get blinking blue or blinking green LED, depending on mode (sometimes i get yellow here, and I do disconnect battery as suggested in the IRIS manual)
7) At this point I attempt to arm by moving the left stick to the lower right -- and I get nothing, unless I disconnect and reconnect the battery. I'd say this happens about 60% of the time.
Thanks,
John