I want to configure not spinning motors when multicopter arms. - PIXHAWK - diydrones

I want to configure not spinning motors when multicopter arms.

Posted by Takato Onishi on April 27, 2016 at 1:21am

Hi All,

I use PX4 ,PX4ioar and PX4 Flight Stack.

I want to configure not spinning motors when multicopter arms.

But I don't know how to configure them.

Please give me advises!!

Thank you.

-Takato

You need to be a member of diydrones to add comments!

Email me when people reply –

Replies

Wojtek April 30, 2016 at 4:28pm

Hi,

Mission Planner --> connect via COM --> CONFIG/TUNING --> Standard Params (left side) --> You need to scroll down until you see "Motors always spin when armed (set : do not spin) :)
- Takato Onishi > Wojtek May 3, 2016 at 12:21am
  
  Thank you for reply, Wojtek!
  
  Actually,I use the flight control software is px4 flight stack not Ardupilot.
  This way is cannot use...
  
  -Takato
Jacques Eloff April 30, 2016 at 2:59am

Could you not just put brake mode on your esc's? Or do you need them to stop in a specific position like on quadplane?
- Takato Onishi > Jacques Eloff May 3, 2016 at 12:25am
  
  Thank you for reply!!
  
  I don't research my esc's brake mode.
  I will try it!
  
  My copter is not need stop in a specific position.
  
  -Takato

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.