hii guys
hii, I have a Pixhawk flight and I have imported the birdseye view firefly 6y airframe with Qground control but its transition mode do not work at all, I did as the pixhawk guide issued but even it did not work again, whats the problem ????
You need to be a member of diydrones to add comments!
Replies
Paul thanks alot <3
babak, if you cannot get solution you may try this post
http://discuss.ardupilot.org/t/tiltrotor-support-for-plane/8805
G'day babk,
I'm no expert but I did recently finish a build & test of a FireFly6.
The AvA firmware has a few functions 'locked out' until you enter a licence key into the parameter file including transition.
If you purchased one of the three options you will need to email the KEY_PID along with your order confirmation to keys@birdseyeview.aero
The KEY_PID is a unique board number used to generate your individual KEY_VALUE which you can save to the parameter file.
Otherwise you will need to modify the ArduPlane-Quadplane (v3.5.0+) firmware with scripts & custom tuning to achieve the same outcome, a sizeable challenge.
hi Paul
what is the Greg Coveys' email address?? how can I connect with him
send him friend req but he did not accept yet
Paul Meier said:
babak sorry I would not know if you can test in a dry run. Did you read firefly own documentation if transition can be done as a dry run ?
PS maybe ask Greg Covey, he is a specialist in firefly
Paul Meier said:
only dry runs
babak sorry I did not read your post well. I want to ask are you actually flying it or only doing dry runs ?
dear Paul
I did as it issued, I do all steps in px4 but its transition mode do not work
-
1
-
2
of 2 Next