No Micro USB port for firmware update

Finishing off the Community User guide before my first flight and found that I do not have a micro usb port to update to.  The only port I have is a 6 pin, looks very similar to a balancing port you would have on a charger.

Any ideas?  I am very hesitant to try and jam a micro usb into this thing,  

I should add that I have another drone that works with Arducopter, so I am very familiar with the firmware upgrade process etc.

Thanks.

20150402_151026.jpg

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Found it.  Had to cut the zip tie and move the cables around.  It was just covered up.

This reply was deleted.