I was wondering if there was a way to take accelerometer/gyro values from Mission Planner and send them over serial or usb to an arduino where I could then run servos and vibration motors? The part I am having trouble figuring out is how I can get l
Read more…I recently recieved my 3DR hexacopter kit with the 880kv motors. I recieved two versions of the same motor in the kit. The one version has a small hole on the top frame and a sticker I believe and only does about 3 full turns when I spin it before it
Read more…Has anyone made a hull for their arducopter hull before? kind of like the ardrone? I was thinking of making one out of lightweight foam and/or fiberglass.
Read more…I'm building a 3dr hexacopter with 880kV motors and 11" props. I'm still at a bit of a loss on what batteries I should get. I've received a few guidelines, but I was wondering if this setup would work? If anyone has any other suggestions for batte
Read more…I've looked through many posts but still have a few questions....
I've been flying a small quadcopter for a while and I plan on buying my first Arducopter in the next few days. So far I think I might go with the following setup.
- APM 2.0, no GPS
- LEA
Read more…