About

Gender

Male


Location

VIC


About Me:

Masters of Mechatronic Engineering Student at University of Melbourne, Australia.


Please tell us a bit about your UAV interest

Working on a final year project at Melbourne University, building a UAV for the 2016 Medical Express Outback UAV competition in Australia. Love working on drones and have thus far built and tested a Y6 Hexacopter, designed (using eCalc), built and tested a Tri-Copter Quadplane (Skywalker X8) with front tilting motors (for Med Express challenge) as well as a smaller Wing Wing chasis Quadplane build.


Hometown:

Melbourne


Activity Feed

Bede Wolf posted a discussion
Hi,My initial problem was my copter falling out of the sky when it loosened 4 of it's 6 props due to the motor nuts thread direction vs it's spin direction (i got CCW motors before i knew better).I have a Y6B set-up, that is;6 Prop, Coaxial Y frame…
Sep 8, 2016
Bede Wolf replied to Bede Wolf's discussion Autotune with Quadplane
"Thank you sir.
I'll repost if i cross any issues.

Bede"
Jul 13, 2016
Bede Wolf posted a discussion
Hey Guys,Just wondering if there's any info out there for how to Autotune with Quadplane.Haven't found anything on Ardupilot or DIYdrones just yet.Do you just us the flight mode AUTOTUNE in both Qhover. Disarm. and then FBWA?Also a bit of info about…
Jul 12, 2016
Bede Wolf replied to Bede Wolf's discussion Building Ardupilot Firmware for Tilt-Rotor Tricopter/Plane (QUADPLANE). "make: *** [px4-v2] Error 2"
"Ok Problem Solved.
Up until now i had been using Source Tree (Git Interface) to clone a branch of the Ardupilot Master Repo. Due to this i had been ignoring the first couple of instructions on the "Building Ardupilot for Pixhawk?PX4 on Windows with…"
Jul 6, 2016
Bede Wolf replied to Bede Wolf's discussion Building Ardupilot Firmware for Tilt-Rotor Tricopter/Plane (QUADPLANE). "make: *** [px4-v2] Error 2"
"Paul,

Matt our team mentor made a fork of the master Ardupilot Repo yesterday using the Source Tree git interface and then i cloned that Repo at the start of today. I have been following those very instructions. I will try clone the Master repo…"
Jul 6, 2016
Bede Wolf replied to Bede Wolf's discussion Building Ardupilot Firmware for Tilt-Rotor Tricopter/Plane (QUADPLANE). "make: *** [px4-v2] Error 2"
"Here is the make.out file with the PX4 console output for the build.
Hopefully it will help.make.out"
Jul 5, 2016
Bede Wolf posted a discussion
Hi,I am trying to build ArduPlane Firmware for a QUADPLANE specific to a Tricopter/Plane structure with 2 forward tilting props/motors.This code has been run in SITL and builds and works.I used the following process and ran into errors:I made a…
Jul 5, 2016
Bede Wolf replied to Bede Wolf's discussion Pixhawk - Back-Up Power via USB port
"Thank You Andre :)

Just what i needed to know."
Jun 7, 2016
Bede Wolf posted a discussion
Hi,I'm building a hybrid UAV with a Pixhawk flight controller for use in a competition. As far as i've understood a requirement of the competition is to have a back-up power supply for the flight controller ONLY (does not power any actuators). I…
Jun 7, 2016