For our UAV project we are using the Pixhawk and Mission Planner 1.3.34. During flight we'd like to adjust the airspeed of the UAV. We are in AUTO mode flying the waypoints and are using the "Change Airspeed" under the ACTIONS tab. However, the speed
Read more…I have a Pixhawk with the latest MP and I'm sure latest firmware (v3.2). I'm connected through the USB albeit the external USB extension. When I go into terminal, I see a lot of noise. What could be the issue? See attached picture. Thanks!
I have a APM 2.5 that had an external GPS. I had an accident where the GPS module was destroyed. I see that 3DR only sells the GPS+Compass module. Can I use that with the APM 2.5 even though it has an internal magnetometer? Is there a way to disable
Read more…Can APM still use FlightGear for hardware-in-the-loop simulation?
Read more…I'm not really sure if this is an issue or not or even where to find it if it is. So when I power up the APM 2.5 with sw load 2.74b, after the initial power-on test the aileron servos would lock up for about 2-3 seconds when I do rapid movements. It'
Read more…I have an APM 2.5 with a power module and J1 is open. The ESC I have has a switch. The ESC is connected to the Output Port 3 on the APM. The power module to connected to the power port on the APM. The receiver is connected to the APM on the input sid
Read more…