I'm fumbling my way through configuring my UAV, and I'm not so good with the code as it has grown and changed a lot recently. I have some wide-ranging questions, and I'm hoping some of the experts out there can weigh in on them. So... running down
I've been trying to run through the test suite to make sure I have everything defined right on my UAV, and I'm confused. The wiki says "Please see the sidebar on the left for instructions for each test and typical data output." But I can't
I'm having a similar problem to what has been posted before, and tried the solutions posted (as far as I can tell) to no avail. I'm running 2.6 on the blue shield with XY and Z IR sensors and pitot tube installed with a Spektrum DX6i Tx and r
Hi everyone,Based on the descriptions on the main ArduPilot site, instruction manual, and code page, I was under the impression that I could run 2.1 on the new board without the shield, and without a Z-sensor. Now that I bought the board, FTDI cable,
