Well this has probably been discussed before, but, my searching unveiled nothing.
The Basics:
Flying at sunset, temperature 12degC, no wind
APM2.5+ with 2.9.1b
Y6 running Turnigy 950kv Motors & ESC, 4S Batteries.
This frame had done around 50 minutes of f
Read more…So I have 2.9.1 on an APM2.5+ and have been doing some bench testing without props.
A striking anomaly occurs at low rpm/throttle, it may also happen at high rpm but isn't as clear.
If I put the stick up just enough to start all the motors spinning. Mo
Read more…3 Hours of flawless flight testing using Stab, Stab Simp & Alt Hold, Try Loiter and Bam, Flyaway.
Well it could have been a lot worse.
I was doing some birds eye view shots of my parents house, Turnigy HAL Frame, converted to coaxial octocopter, 3DR AP
Read more…Well this one is really doing my head in.
Have been trying to setup the gimbal, but which ever axis is connected to RC11 just twitches randomly and aggressively all over the place.
Also as an aside, are RC1-8 the same as outputs 1-8? trying to work out
Read more…Hi All,
I'm running the APM2.5+ with Arducopter 2.8.? (The version before 2.9)
My Radio is a Spektrum DX8.
All of the radio calibration went fine, but I noticed at the time of calibration that the throttle 'green bar' would randomly blip up to half thro
Read more…