Gender
Male
About
Location
Oklahoma City, OK
About Me:
architect
Please tell us a bit about your UAV interest
hobby
Hometown:
Oklahoma City
Activity Feed
"I'm having the same issues w/ compass & data flash that def2att described Dec 2012. Any solution?"
"Just did CLI test on GPS and it seemed to report it was fine.
Did CLI test on compass and report said "Not Healthy"."
Did CLI test on compass and report said "Not Healthy"."
"I just noticed/confirmed, Mission Planner Flight Data page gives message, "No GPS". I had GPS when I first loaded firmware and flight data showed it locked on my house - 3 days ago..."
"Tx in mode 2.
No signal from Rx is recognized by the board unless I'm in ESC calibration.
I can calibrate ESCs, but can't arm the system afterwards. Also, I now don't get a GPS response."
No signal from Rx is recognized by the board unless I'm in ESC calibration.
I can calibrate ESCs, but can't arm the system afterwards. Also, I now don't get a GPS response."
"Mike, Tx is set to acro. Throttle bar was only moved in MP by throttle, but Rudder was moved by roll & roll was by rudder. That's why I initially thought receiver wires were wrong, but they checked out right (see Logan's comment below). Now I can't…"
"Bo, good thought, but I read the same note about trimming throttle - tried it but no change."
"Logan, thank you for your help. However, the hook-up you suggested is what I have on my set-up, so I guess that's not my issue. What's odd is that the board did power up initially and I went through the initial RC set-up with calibrating the sticks;…"
I just bought my APM 2.5 from DIYdrones to hook it up to my simple tricopter. Can anyone help with a wiring diagram to connect my spectrum receiver properly to the board? I'm using the power module to power the APM board. I've loaded the firm ware…
"I just bought my APM 2.5 from DIYdrones to hook it up to my simple tricopter. Can anyone help with a wiring diagram to connect my spectrum receiver properly to the board? I'm using the power module to power the APM board. I've loaded the firm ware…"
