Gender
Male
About
Location
Myrtle Beach, SC
About Me:
Tinkerer
Please tell us a bit about your UAV interest
Anything autonomous is interesting to me.
Hometown:
Myrtle Beach, SC
Activity Feed
"Just received my Reach kit in the mail. Nice to see that they took the time to get nice packaging made up for the devices. The devices are much smaller and lighter than I expected. I have not touched or configured them yet. I am going to wait until…"
"Tom:
I did put an amp clamp on one of the motors.
Without pegging the throttle I was able to determine that current during normal travel across pavement or grass did not exceed 10 amps. The peak was actually 7.9 amps. If I purposely stall the motor…"
I did put an amp clamp on one of the motors.
Without pegging the throttle I was able to determine that current during normal travel across pavement or grass did not exceed 10 amps. The peak was actually 7.9 amps. If I purposely stall the motor…"
"What is the model and brand of your ESC?
I am using a Dimension Engineering 2x32 ESC.
I currently have it set to independent channel mode (no mixing)
Sabertooth Controller 2x32
It does support reverse.
The device, by default, will learn throttle…"
I am using a Dimension Engineering 2x32 ESC.
I currently have it set to independent channel mode (no mixing)
Sabertooth Controller 2x32
It does support reverse.
The device, by default, will learn throttle…"
"So no takers on this problem??
Really unsure on how to proceed.
A hint in the right direction is all I ask for.
Thanks"
Really unsure on how to proceed.
A hint in the right direction is all I ask for.
Thanks"
"#NOTE: 5/12/2015 9:48:08 PM Frame :…"
"Okay no problem.
File attached.
Thanks.
For future reference should I post the actual parameters in-line or is it better to just attach the actual file?
WheelchairSet.param"
File attached.
Thanks.
For future reference should I post the actual parameters in-line or is it better to just attach the actual file?
WheelchairSet.param"
This is my first Pixhawk build.Pretty much have a Jazzy wheelchair subframe set up in skid steer.Using a 2x32 Dimension Engineering ESC in "independent channel" mode.Using a low cost 6 channel E-Sky radio and receiver.I can successfully drive the…
"Okay you have won my support. I have just sent my support payment and hope to see wonderful things from you guys over the next couple of weeks. Please post videos of your integration progress with APM & Pixhawk platforms as you make progress.
Thanks!"
Thanks!"
"This is precisely what I have been looking for!
But I have to say with all honesty, and no intention of causing any bad feelings , this whole Indiegogo thing is something that is really alien to me. As the consumer, how are we protected? This is one…"
But I have to say with all honesty, and no intention of causing any bad feelings , this whole Indiegogo thing is something that is really alien to me. As the consumer, how are we protected? This is one…"
I am very new to this but I have done a bit of reading prior to making this, my first post.I am sorry for the insane amount of config information I am about to list here but from reading post after post I always find an experienced member always…
