Gender
Male
About
Location
Abingdon, MD
About Me:
Hobbyist
Please tell us a bit about your UAV interest
Interested in multi copters for arial photography.
Hometown:
Abingdon
Activity Feed
"I though you guys would like this. I received a bad board from GoodLuckBuy, and sent it back. I got the new one today and plugged it in and "Bad Gyro Health". I checked the voltage, and it was fine. I looked at the compass on the GPS board…"
" I wish I could. I bought this thing over 5 months ago, and have known it was defective for quite some time. I also bought another one from ebay, and it was labeled Ardupilot. It looked to be much better quality, but the GPS did not work so I sent…"
"Thanks for the comments everyone. Does anyone know where I can find a complete schematic showing all the traces? The protective layer on this board is so thick and sloppy, I can barely see the traces.
Also, should the board normally power up at all…"
Also, should the board normally power up at all…"
"I am in Baltimore, MD. The board is a Hextronic from Hobby King. This was my first attempt with the APM. I was using the KK2.0 board before with a lot of success.
This board never even made it in the air. I was just playing around with it in…"
This board never even made it in the air. I was just playing around with it in…"
"Hello, I have been playing with a APM 2.5.2 board with a blown up regulator. I was able to remove and replace the small smd regulator. The voltage after the repair when measured at the 12c port was still approx. 4.7 volts. I thought it was a bad…"
