"Hi Thomas,
Are you referring to Cedi's post or my question?

If mine, I was not able to find the PCB image for Pixhawk 3 either.

Does the contents of this link give the required info?
https://pixhawk.drotek.com/en/power-architecture.html

Also, the…"

"Hi Armin,
Thank you very much for the suggestion. I am using that to check if sensor_mag values are provided individually.But I am only able to find the fused magnetometer value.It shows up in the second pic as "M1:HIGHRES_IMU.xmag" etc.
How do I…"

"Hi Armin,
The plots that you see in the beginning is not my case. That was the case from the original poster, Cedi. My question is how to get those plots so that I can investigate my case further. Armin Strobel said:
Same direction, but it looks…"

"Hi Armin,

Thanks for the insight. Actually, I have set the system such that vehicle and the external compass points in the same direction. Before calibration of the compass in PX4 firmware, I have set the orientation of auto-pilot and the external…"

"Hi @Cedi,
Did you figure out your issue? I am also facing a similar problem.
But first, may I know how did you plot up those sensor_mag values? Is there a parameter to enable to visualize the mag values separately?
Regards,"