Drone Tinker's Discussions

Drone Tinker's Discussions (2)

Sort by

PX4 + IO Board, Gross Failsafe Malfunction

So I was making a test flight with my multirotor platform this week using the PX4 stacked setup
and all of a sudden the RC receiver link was lost. Failsafe is set to RTL or land upon low PWM
or no receiver detected. I check if this status message disp

RFD900 Telemetry will not connect in Mission Planner. All settings tried.

Edit: Fix in the comments below

Hi, I've been trying for a few days now and can't figure out these radios. I am using the PX4 platform and when I configure the modems with either the 3DR config tool or the RFD900 Modem tool, the radios seem to connect

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

PX4 + IO Board, Gross Failsafe Malfunction

RFD900 Telemetry will not connect in Mission Planner. All settings tried.

Note: this page contains paid content.