Gender
Male
About
Location
ottawa
Please tell us a bit about your UAV interest
I just made my first quadcopter
Hometown:
ottawa
Activity Feed
"Hey Mario, I've already tries flying with the compass connected to both the i2c and can bus ports and have seen no difference."
"Hi Micheal, I just replaced the foam tape I was using to hold the FC on to the frame with a brick of squishy Styrofoam. I'll attach a photo of the flight controller and a log from when I flew it today. The same issue occurred today when I switched…"
"Is there a way I can fix these issues?
Is there another way we can talk because i'm having problems with diydrones that is not letting me reach the page unless i refresh the page multiple times.
Thanks Cala said:
It's a tipical movement that…"
Is there another way we can talk because i'm having problems with diydrones that is not letting me reach the page unless i refresh the page multiple times.
Thanks Cala said:
It's a tipical movement that…"
"Is there a way I can fix these issues?
Is there another way we can talk because i'm having problems with diydrones that is not letting me reach the page unless i refresh the page multiple times.
Thanks Cala said:
It's a tipical movement that…"
Is there another way we can talk because i'm having problems with diydrones that is not letting me reach the page unless i refresh the page multiple times.
Thanks Cala said:
It's a tipical movement that…"
"btw I am using QgroundControl since APM planner doesn't seem to work with the current update and I am on a mac."
"Hi Cala, I already have COMPASS_USE2 set to 0 (False), compass_external set to enabled and COMPASS_PRIMARY set to first compass. Right before you replied I went out to test it and see if it would still roll and flyaway in loiter mode, but this time…"
For the past while I've been having problems with my compass (EKF and DCM errors resulting in change of heading) that have made it almost impossible to fly since I fly in simple mode. I was on arducopter 3.2.1 and after updating to 3.3 the errors…
