Hi im wanting to build a new tracked vehicle using brushless gear. My first option was to see if anyone knew of any brushless ESC which have programmable Brake disabling and reverse 100% so that when turning on the spot I want both left and right mot
Read more…Hi Im wondering is anyone out there could offer me some help. I have a DX8 Spectrum Remote for my FPV setup and I have built a dome camera set up so full pan and 45 degree downward tilt. Now I want to know if I can either use one of the Aux switches
Read more…I am trying to connect all my cables to the APM and my receiver but I don't know where my ESC cables should go or where the receiver power cable comes from?? It only mentions it later on in the instructions.
Any help please!!!!!
Read more…I have just put my Ardupilot Mega (ATMega2560) and now I am attempting to upload the firmware. I have tried to use mission planner 1.1.22 and when i select arducopter for quad it comes up with an error saying " Failed to download new firmware:System.
Read more…When I placed my props on the motors using the prop adapters DIY drones supplies with their motors I notice they are not very precise. I know balancing props is important but these adapters are going to cause vibrations too! How bad is vibration from
Read more…All I want to know is what everyone uses in terms of batteries and how much flight time you get from them.
THANKS
Read more…Hi all
I purchased a Arducopter and im lookign to get the best flight times I can. I have seen somewhere a guy using two 5000mah 3s lipos is it worth going that far? Would two 8000mah 3s lipos be far FAR too much?
Read more…It has been for ever since I last came on this site but finally I have purchased myself a quadcopter and wireless FPV system. My video set up is a 900mhz Range Video RX and TX with a KX191 colour camera. Now my problem is the reception, I have done t
Read more…hi all im new to auto pilots and things for airplanes. Im having trouble finding exactly what i need for a full set up can anyone tell me? i have looked around and i would like to use a RangeVideo OSD i see that there are some sensors and a GPS modul
Read more…