Hello!
I don't understand. I have 2 Ardupilot Mega (V1.4 and old version) with a strange problem.
The V1.4 doesn't have any reaction (blue led off) when I power up the board plugged on my receiver, however the receiver get power from the board....
The o
Read more…Hello!
I have a big problem
I connect my boards to USB port.
Rx/Tx together blink 3 times and nothing ... everything power down except the blue Led from ArduMega and the red, yellow, blue on the red board.
It is very strange because I put code well befo
Read more…Hello!
I'm trying to install Labview drivers on my Laptop to setup PID values (with Configurator) outside but with no success. It always says that it can't locate 2009 SP1 Runtime Labview drivers ...
I did it on my home PC and I had no problem ...
Is th
Read more…Hello!
I need help please!
I'm doing the last pre-flight tests and I'm worry about one reaction from my Arducopter.
When I test yaw compensation, my Arducopter wants to flip.
When I watch my gyros in Configurator, I see the Roll Gyro that show fluctuatin
Read more…Hello!
I'm trying to setup my Arducopter with Configurator 1.2.2. but it fails when it tries to connect my Arducopter. It writes "reading configuration" and nothing happens. I put 30 sec timeout and my USB port is the right one.
I don't know if it is c
Read more…