About

Gender

Male


Location

Stockholm


Please tell us a bit about your UAV interest

Addicted.


Hometown:

Stockholm


Activity Feed

Fredrik T replied to Fredrik T's discussion Issues with radio modules in APM and Mission Planner
"Make sure that your COM port number (COM1,2,3,4,5,6,7..) is correct. You can view the COM-port number i device manager.Also try to connect directly when you start MP, before you try to retrieve the information from your telemetry modules."
Aug 11, 2014
Fredrik T replied to Fredrik T's discussion Trying to get my Dualsky Hornet flying with APM 2.6 - very unstable!?
"I solved my problem and had my first successful flights today. Thought I would share what I did wrong so that someone might learn from my mistakes.

First fault was my pitch setting. I thought that the slider in Mission Planner would move up when I…"
May 3, 2014
Fredrik T posted a discussion
Hi!Today I took my quad out for a test flight. I never made it to any heights..., I settled for bouncing around on the ground. This is my first try with APM, I've just used Dualsky's FC450 and DJI's Naza FC before:. Anyway I got some issues which I…
Apr 27, 2014
Fredrik T posted a discussion
Hi!I've spent some time trying to understand why I can't use my radio modules to connect to Mission Planner. The radios, which are not genuine 3DR as far as I know, works fine in the 3DR radio configuration software and I can see booth units in the…
Apr 26, 2014
Fredrik T replied to Fredrik T's discussion ESCs getting hot without load
"Hi Chris!

Thanks for the reply. There are no red wires going into the APM from the ESCs/BECs. But on this model the cables are not running directly from the ESCs to the FC, they run through the bottom board which makes it hard to tell exactly how…"
Apr 18, 2014
Fredrik T posted a discussion
Hi!I started to rebuild my Dualsky Hornet 460 with the goal to replace the traditional flight controller (FC450) and exchange it to a APM 2.6. This is my first build with APM, so bare with me. I've connected the APM to my ESCs and receiver and gone…
Apr 18, 2014