WP upload
A question about WP read writes.
How does it works?
Like i have made my flight plan, added my WPs than pushed disconnect. (connected directly trough BT)
But it did not take.
Thx,
Gábor
Read more…Gábor Zoltán's Discussions (8)
Sort by
Pre flight calibration
Sure Kevin, :)
The thing i meant is the sensor warming up problem.
It is related to a design flow of the hardware. (It should measure external temp, not "internal")
Like the barometric sensor is located on the main board, it heats up wit APM a bit.
But a
Read more…FPV videos
Please post as many videos you can. But please only post your own. ;)
This is my latest:
Read more…
Adding extra functions to MinimOSD
I have started to add functions to MinimOsd code.
At first i did it for myself only. Added many functions i thought i need. Then opened this thread.
after a while, Pedro and later Miguel came, and things started to happen fast. :D
They have optimised th
Read more…Could it be PPM encoder problem?
It happened to me twice that i had failsafe, and APM1 did not react. My pan tilt did go to center, so the receiver did work well. (It is a Futaba Futaba R149DP)
This is very confusing. Sooner or later i will lose my beautiful plane this way for sure.
Read more…Unstable throttle
I was flying today, and my throttle did not react as it should.
Like i set throttle to 100%, than it suddenly went back to 20%.
It happened many times today.
Do you know why? :(
Read more…APM1 current draw and powering
I have a very inaccurate ammeter. It did show that my APM1 is using more than 500ma!
GPS, magnetometer, airspeed sensor, and Minim OSD was connected.
I have found this impossible, as manual states that there is a 500ma fuse inside of APM1.
Some people a
Read more…Unreliable barometric altitude (Arduplane 2.30)
Just got into this about 2 weeks ago, and really enjoyed it.
It is so much fun! :)
But today I experienced this pitch down and dive hard unexpected movements that my plane made.
I took off 3 more times, everything seamed ok, in the begining, but sudden
Read more…