Garrett's Discussions

Garrett's Discussions (2)

Sort by

How can I used the AUX servo outs 1,6 as PWM for DodecaHexa?

I have calibrated ESC on all motors, but to do so I had to swap the esc signal wires top (1-6) for bottom (7-12). I'm connected to 1-6 main and aux. Only the main seem to be working, but all motors and escs work fine. My Autostart code is set to 2400

Two motors start spinning at full throttle after I connect battery when not armed!

I'm admittedly new to this so it's possible I'm just making a very stupid mistake but I can't seem to figure out what's going wrong. When I plug in the battery on my hexa copter - two of the motors immediately start spinning within about five seconds

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

How can I used the AUX servo outs 1,6 as PWM for DodecaHexa?

Two motors start spinning at full throttle after I connect battery when not armed!

Note: this page contains paid content.