Harold Sweat's Discussions

Harold Sweat's Discussions (2)

Sort by

APM Output Channel 2 not working

I've set up my quad with an APM 2.6 and everything is working.... except the output channel 2. I can turn the APM on, arm the motors and get them spinning except which ever motor is plugged into channel 2. I've plugged in different motors into that

APM loud sustained beep

I'm trying to connect my APM 2.5 to the mission planner software. When I plug in the USB the the APM starts up and the A & C lights start flashing, however after a few seconds the board lets out a loud sustained beep and does not end until I remove

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

APM Output Channel 2 not working

APM loud sustained beep

Note: this page contains paid content.