Gender
Male
About
Location
Cambridge
About Me:
Robotics Engineer, RC Model Helicopter Enthusiast
Please tell us a bit about your UAV interest
Interested in autonomous / assisted flight from many perspectives
Hometown:
Cambridge UK
Activity Feed
I'm building a medium sized drone (wheelbase 600 mm). When I spec'd the motors/props I went for an 8S setup as this appeared better for flight time (thrust per amp looked best for the motor size I was looking for) and keeping the current down seemed…
"HI There,
Thanks very much for the reply. I'll read the quad manual too before I set the heli up.
So with helis vs quads.... the firmware compiled changes but the source covers both types... ok cool :-)
With 2.9, will there be a variable I can…"
Thanks very much for the reply. I'll read the quad manual too before I set the heli up.
So with helis vs quads.... the firmware compiled changes but the source covers both types... ok cool :-)
With 2.9, will there be a variable I can…"
"Update: Found the pinouts of the APM 2.0/2.5 in Arduplane manual and some other details of the boards so now I'm getting somewhere...."
Hi All,I have been looking at this site for about a year with great interest before finally pushing the button on a APM 2.5 last week. Now it's here I have a few questions before leaping in....I work in life science automation so I have a good…
Hello out there,Please could some provide me with the dimensions for the APM2.0 board including GPS daughter board? Dimensions with / without the optional case would be very helpfull. Additionaly are there any standard recommendations for mounting…
