Gender
Male
About
Please tell us a bit about your UAV interest
Pixhawk
Hometown:
Israel
Activity Feed
"I found the problem now, two of my ESC (the ones that I switch between are defect).
I connected each of the 4 ESC + 1 spare to RPI and let it spin the motor, after some seconds the motor start spinning back and forth.
Do I need to flash or configure…"
I connected each of the 4 ESC + 1 spare to RPI and let it spin the motor, after some seconds the motor start spinning back and forth.
Do I need to flash or configure…"
"I replaced the ESC cable, and connected ESC of motor 1 to pixhawk port 2 and now the motor spins ok.
So the problem is defiantly with the pixhawk port 1, or should I configure something for port 1 in pixhawk"
So the problem is defiantly with the pixhawk port 1, or should I configure something for port 1 in pixhawk"
"Thanks for your reply.
I think that the pixhawk is defective, but before I send it back to bangood. I want to be sure that the problem is with the pixhawk.
Does the log shows defective hardware and problems like this?"
I think that the pixhawk is defective, but before I send it back to bangood. I want to be sure that the problem is with the pixhawk.
Does the log shows defective hardware and problems like this?"
Hi,This is my first quad and I'm very frustrated that I'm unable to fly it.I configure it with the mission planner wizard.When I arm the quad the props start to spin, but some of them are slowly. then If I raise the throttle a little, the props spin…
