I use my quad for aerial videography of kiteboarders. My main mode of operation usually involves using alt-hold (and more recently loiter) to set an altitude just beyond the reach of the kites (~30m above the water level) This allows me to better foc
Read more…I had an unfortunate incident this afternoon which has cost me all my copter electrics including my Panasonic HDC TM700 camera. I had been through four battery packs without incident when suddenly my 2.9.1b quad started loosing altitude, ending up in
Read more…My receiver outputs received signal strength and I have connected this to the A0 pin on the APM. I have set the RSSI_PIN paramenter appropriately and can display the RSSI correctly in the MP while the quad is attached to my PC. Is there any way I can
Read more…I have previously used ch6 to tune individual parameters without any problems. Recently I have attempted to fine tune alt hold using the same method but now when I attempt to configure ch6 to alter any parameter, I get unexpected results.
For instance
Read more…Just a reminder for those folk that are running their APM 2.5 without an enclosure. I ordered my APM unassembled as the assembled version was not available at the time. This was just on the transition from 2.0 to 2.5 and even though I ordered a 2.0,
Read more…