Hi,
I recently revised my miniquad design and have some hardware left over from my first version.
1. Miniquad frame:
This frame is built using 1mm carbon plate and 4mm pultruded carbon tubing. Tubing is reinforced with internal fiberglass ferrules that
Hi,
I recently had a bad crash and the 3.3V voltage regulator on the Oilpan that is located close to the I2C port was damaged. I replaced it with an absolutely identical chip (got the correct part number from the DIYDrones store). Now I have a couple
Read more…Hi,
I suffered a pretty bad crash last week and since then I can't get my compass to work anymore. However, I am not sure if it's the compass that's actually broken or maybe my IMU board.
Hi,
I'm just starting out with my Arducopter project and still have a lot to learn about the code, so pardon me if this question has been addressed before.
I understand that the autopilot main loop runs at 100 or 200 Hz, I read this in another topic. M
Read more…